Vacuum Plasma Treater | VacuTEC 2020
FEATURES: | |
Easy to install and use | Connect to mains power. |
Fast treatment times | High power impact enables treatment times from 20-120 seconds, depending on material. |
Vacuum level | The plasma discharge is active from 0,1 – 3 mbar depending on application. |
Process gas | Process gasses such as oxygen and argon can be used, but in most cases it is not necessary. |
Process control | The entire plasma process is controlled by the HV-X generator and the PLC unit. All parameters are displayed through the touch panel. |
Cost efficient surface treatment |
Due to the low power consumption and no need of special treatment gasses the unit is a very cost efficient solution for improving surface wettability and adhesion. |
Vacuum pressure Plasma | Enables treatment of both conductive and non-conductive surfaces. |
Chamber door | Hinged door with window and safety switch. |
Technical Specifications | VacuTEC 2020 | Vacuum Plasma Treater |
Mains voltage and frequency | 100-480 VAC 50/60 Hz |
Output voltage/plasma power | Max. 350 Vp/max. 350 Watt |
Power source | Standard HV-X generator |
Compressed air inlet | 3 bar dry & clean |
Treatment gas | Standard: air, oxygen, argon, nitrogen on request |
Vacuum pump capacity in m³/min. | 50 m³/min., others on request |
Vacuum level | 0,1–3 mbar |
Evacuation time, typical | 22 seconds – 1 mbar |
Plasma treatment time, typical | 20–120 seconds, depending on material |
Control and connectivity | Complete with Tantec touch panel. |
Regulation compliance | CE – RoHs – WEEE |
Dimensions | 752 x 503 x 432 mm |
Weight | 80 kg |
Max. treatment height | 105 mm |
Tray size | 200 x 200 mm |