Vacuum Plasma Treater | VacuTEC 2020

Tantecs VacuTEC 2020 Plasma Treater is designed for treatment of a large number of different injection moulded parts. The VacuTEC offers very fast treatment times and optimum adhesion properties for downstream coating, gluing, painting and printing applications.In the treating chamber a vacuum is built up to between 0,1 and 3 mbar before an electrical discharge is created through the integrated plasma electrode. Treatment cycle times are often short, between 20-120 seconds depending on the material and its formulation.The VacuTEC is appreciated for its simplicity of operation, reliability in production and fast process speed. Treating gasses such as argon and oxygen can be applied, but in most cases this is not necessary due to the high power exposed by the plasma discharge.VacuTEC uses the advanced Tantec power generator HV-X series as power supply and specially designed plasma transformer to provide voltage to the plasma electrodes.

FEATURES:
Easy to install and use Connect to mains power.
Fast treatment times High power impact enables treatment times from 20-120 seconds, depending on material.
Vacuum level The plasma discharge is active from 0,1 – 3 mbar depending on application.
Process gas Process gasses such as oxygen and argon can be used, but in most cases it is not necessary.
Process control The entire plasma process is controlled by the HV-X generator and the PLC unit. All parameters are displayed through the touch panel.
Cost efficient surface
treatment
Due to the low power consumption and no need of special treatment gasses the unit is a very cost efficient solution for improving surface wettability and
adhesion.
Vacuum pressure Plasma Enables treatment of both conductive and non-conductive surfaces.
Chamber door Hinged door with window and safety switch.
Technical Specifications VacuTEC 2020 | Vacuum Plasma Treater
Mains voltage and frequency 100-480 VAC 50/60 Hz
Output voltage/plasma power Max. 350 Vp/max. 350 Watt
Power source Standard HV-X generator
Compressed air inlet 3 bar dry & clean
Treatment gas Standard: air, oxygen, argon, nitrogen on request
Vacuum pump capacity in m³/min. 50 m³/min., others on request
Vacuum level 0,1–3 mbar
Evacuation time, typical 22 seconds – 1 mbar
Plasma treatment time, typical 20–120 seconds, depending on material
Control and connectivity Complete with Tantec touch panel.
Regulation compliance CE – RoHs – WEEE
Dimensions 752 x 503 x 432 mm
Weight 80 kg
Max. treatment height 105 mm
Tray size 200 x 200 mm